Black & Decker FSM1630S manual

Black & Decker FSM1630S

El manual de Black & Decker FSM1630S se puede ver a mano derecha. La descarga dura algunos momentos. La descarga de este manual es completamente gratuíta.

Marca
Black & Decker
Modelo
FSM1630S
Producto
EAN
5035048458266
Idioma
Holandés, Inglés, Alemán, Francia, Español, Italiano, Sueco, Portugués, Danés, Noruego, Finlandés, Griego
Tipo de archivo
PDF
Website
http://www.blackanddecker.com/
4
ENGLISH
(Original instructions)
Intended use
Your Black & Decker steam mop has been designed for
sanitising and cleaning sealed hardwood, sealed laminate,
linoleum, vinyl, ceramic tile, stone and marble oors and for
refreshing carpets. This appliance is intended for indoor
household use only.
Warning! Read all of the 'Safety, Maintenance,
Service' manual carefully before operating
this appliance.
Read all of this manual carefully before operating
the appliance.
Features
This appliance includes some or all of the following features.
1. ON/Off switch
2. Autoselect
TM
button
3. Removable water tank
4. Handle
5. Steam head
6. Steam head cleaning pad
7. Carpet glider
8. Bottom cable tidy hook
9. Top cable tidy hook
10. Cable management clip
Assembly
Warning! Before attempting any of the following operations,
make sure that the appliance is switched off and unplugged
and that the appliance is cold and does not contain any water.
Attaching the handle (Fig. A)
u Slide the bottom end of the handle (4) into the top end
of the steam mop body (13) until it clicks into place. The
arrow on the handle (4) should be aligned with the top of
the steam mop body (13).
Attaching the steam head (Fig. B)
u Slide the bottom end of the steam mop body (13) onto the
steam head (5) until it clicks into place.
u The steam head can be removed from the Steam mop
body by pressing the steam head release button (14) and
pulling the steam mop body (13) off the steam head (5).
Attaching the water jug (Fig. C)
u Clip the water jug (3) onto the handle (4).
u Slide the water jug (3) down into the Steam mop body
(13), ensure that the water jug is rmly seated.
Attaching a cleaning pad (Fig. D)
Replacement cleaning pads are available from your Black &
Decker dealer:- (cat. no. FSMP20-XJ).
Steam head cleaning pad - cat. no. FSMP20-XJ).
u Place a cleaning pad (6) on the oor with the ‘hook & loop’
side facing up.
u Lightly press the steam mop down onto the cleaning pad
(6).
Caution! Always place your steam mop with the handle (4) in
the upright position when stationary and make sure the steam
mop is turned off when not in use.
Removing a cleaning pad (Fig. E)
Caution! Always wear suitable shoes when changing the
cleaning pad on your steam mop. Do not wear slippers or
open toed footwear.
u Return the handle (4) to the upright position and turn the
steam mop ‘OFF’.
u Wait until the steam mop cools down. (approximately ve
minutes)
u Place the front of your shoe onto the cleaning pad removal
tab (15) and press down rmly.
u Lift the steam mop up off the cleaning pad.
Caution! Always place your steam mop with the handle (4) in
the upright position when stationary and make sure the steam
mop is turned off when not in use.
Filling the water tank (Fig. F)
The watertank on your steam mop is removable for convi-
enient and easy lling.
This Steam Mop incorporates an anti-calc system to help
prolong the life of the system.
Note: Fill the water tank with clean tap water.
Note: In areas of very hard water, the use of de-ionised water
is recommended.
u Remove the water tank (3).
u Open the ller cap (19) by pressing the release button
(20).
u Fill the water tank (3) with water.
Warning! Your water tank has a 0.5 litre capacity. Do not over
ll the tank.
u Re-t the ller cap (19).
u Re-t the water tank (3).
Note: Ensure the ller cap is rmly secured.
Note: Do not use chemical cleaners with your steam mop..
Attaching the carpet glider (Fig. G) (For use on
carpets only)
u Place carpet glider on the oor.
u Attach a cleaning pad (6) to the unit.
u Lightly press the steam mop down onto the carpet glider
(7) until it clicks into place.

¿Tiene alguna pregunta del "Black & Decker FSM1630S "?

Si tiene alguna pregunta sobre "Black & Decker FSM1630S" puede formularla aquí. Intente realizar una descripción clara de su problema de manera que otros usuarios y/o la redacción puedan proporcionarle una respuesta adecuada.

En venta a

Especificaciones

Diseño
Tipo Escoba limpiadora a vapor
Capacidad 0.5 L
Longitud del cable 6 m
Color del producto Azul
Control de energía
Potencia 1600 W
Voltaje de entrada AC 230 V
Desempeño
Tiempo de preparación 0.25 min
Tiempo de funcionamiento 20 min
Ergonomía
Luz de indicador de vapor listo yes
Diseño de plancha ergonómico yes
Indicador de nivel de agua yes
Interruptor de encendido/apagado integrado yes
Reservorio de agua extraible yes
Almacenamiento de cable yes
Peso y dimensiones
Peso   3400 g
Contenido del embalaje
Paño de limpieza yes