Omron RS6

Omron RS6 manual

  • Thank you for purchasing the OMRON RS6 Wrist Blood Pressure
    The OMRON RS6 is a compact and easy to use blood pressure
    monitor, operating on the oscillometric principle. It measures your
    blood pressure and pulse rate simply and quickly. For comfortable
    controlled inflation without the need of pressure pre-setting or
    re-inflation the device uses its advanced “IntelliSense” technology.
    Intended Use
    This product is designed to measure the blood pressure and pulse
    rate of people within the range of the designated wrist cuff, following
    the instructions in this instruction manual.
    It is mainly designed for general household use. Please read the
    Important Safety Information in this instruction manual before using
    the unit.
    Please read this instruction manual thoroughly before using the
    Please keep for future reference.
    For specific information about your own blood pressure,
    Consult your doctor prior to using in pregnancy or if diagnosed with
    arrhythmia or arteriosclerosis.
    Please read this section carefully before using the unit.
    • Indicates a potentially hazardous situation which, if not avoided,
    could result in death or serious injury.
    (General Usage)
    • Always consult your doctor. Self-diagnosis of measurement results
    and self-treatment are dangerous.
    • People with severe blood flow problems, or blood disorders, should
    consult a doctor before using the unit, as cuff inflation can cause
    internal bleeding.
    (Battery Usage)
    • If battery fluid should get in your eyes, immediately rinse with
    plenty of clean water. Consult a doctor immediately.
    • Indicates a potentially hazardous situation which, if not avoided,
    may result in minor or moderate injury to the user or patient or
    damage to the equipment or other property.
    (General Usage)
    • Do not leave the unit unattended with infants or persons who
    cannot express their consent.
    • Do not use the unit for any purpose other than measuring blood
    • Do not use a mobile phone or other devices that emit
    electromagnetic fields, near the unit. This may result in incorrect
    operation of the unit.
    • Do not disassemble the unit or wrist cuff.
    • Do not operate the unit in a moving vehicle (car, airplane).
    (Battery Usage)
    • If battery fluid should get on your skin or clothing, immediately rinse
    with plenty of clean water.
    • Use only two “AAA” alkaline (LR03) batteries with this unit. Do not
    use other types of batteries.
    • Do not insert the batteries with their polarities incorrectly aligned.
    • Replace old batteries with new ones immediately. Replace both
    batteries at the same time.
    • Remove the batteries if the unit will not be used for three months or
    • Do not use new and used batteries together.
    General Precautions
    • Do not apply strong shocks and vibrations to or drop the unit.
    • Do not take measurements after bathing, drinking alcohol or
    caffeine, smoking, exercising or eating.
    • Do not inflate the wrist cuff when it is not wrapped around your
    • Read and follow the “Important information regarding Electro
    Magnetic Compatibility (EMC)” in the Technical Data Section.
    • Read and follow the “Correct Disposal of This Product” in the
    Technical Data Section when disposing of the device and any used
    accessories or optional parts.
    Main unit:
    2.1 Installing/Replacing the Batteries
    • If the battery low symbol ( ) appears on the display, turn off
    the unit then replace both batteries at the same time.
    • The measurement values continue to be stored in memory
    even after the batteries are replaced.
    Disposal of used batteries should be carried out in accordance
    with the national regulations for the disposal of batteries.
    2.2 Setting the Date and Time
    • If the batteries have been removed, the date and time setting
    will need to be reset.
    • If the date and time are not set, “-:--” appears during or after
    3.1 Applying the Wrist Cuff
    Do not apply over clothing.
    3.2 How to Sit Correctly
    • Relax your wrist and hand. Do not bend your wrist back, clench
    your fist, or bend your wrist forward.
    3.3 Taking a Reading
    • To cancel a measurement, press the START/STOP button at
    any time during measurement.
    • Remain still while taking a measurement.
    After the Positioning symbol lights for more than 2 seconds,
    the wrist cuff will start to inflate automatically.
    Cuff Wrapping Guide
    The Cuff Wrapping Guide is a unique feature that
    indicates if the cuff is not wrapped tightly enough
    around the wrist. Even when the
    is displayed, a
    blood pressure reading will be taken.
    Note: This reading is NOT reliable due to the incorrect
    wrapping of the cuff. Please wrap the cuff again, taking
    care to wrap it correctly and take the measurement
    again. When the is displayed, the cuff is correctly
    wrapped tightly enough on the wrist and the reading is
    accurate and reliable.
    The monitor automatically stores the measurement in its memory.
    It will automatically turn off after two minutes.
    This criteria is for home blood pressure measurement.
    If the irregular heartbeats cause the measurement to be
    invalid, no result is shown. If the irregular heartbeat symbol
    ( ) is shown after you have taken a measurement, repeat
    the measurement. If the irregular heartbeat symbol ( ) is
    shown frequently, please make your doctor aware of it.
    • The blood pressure can differ between the right arm and the
    left arm, and therefore also the measured blood pressure
    values can be different. OMRON recommends to always use
    the same arm for measurement. If the values between the
    two arms differ substantially, please check with your
    physician which arm to use for your measurement.
    Self-diagnosis of measured results and treatment are
    dangerous. Please follow the instructions of your doctor.
    3.4 Setting the Positioning Sensor
    Wrist Blood
    Pressure Monitor
    Model RS6
    Instruction Manual
    Important Safety Information
    A. Wrist cuff
    D. Memory ( ) button
    B. Battery compartment
    E. Date/Time setting ( ) button
    C. Display F. START/STOP button
    G. Memory symbol
    H. Systolic blood pressure
    I. Diastolic blood pressure
    J. Battery low symbol
    K. Heartbeat symbol
    (Flashes during measurement)
    L. Pulse display and Memory
    M. Irregular heartbeat symbol
    N. Movement error symbol
    O. Deflation symbol
    P. Average value symbol
    Q. Date/Time display
    R. Blood pressure level indicator
    S. Positioning indicator
    T. Positioning symbol
    U. Cuff wrapping guide
    Remove the battery cover.
    Insert two 1.5V “AAA”
    alkaline (LR03) batteries
    as indicated in the battery
    compartment and then
    replace the battery cover.
    Press the button.
    Set the monitor to the correct date and time
    before taking a measurement for the first time.
    Press the START/STOP button to store the setting.
    1. Overview
    2. Preparation
    1) Push the button to change.
    Hold down to advance the digit
    2) Push the button to confirm.
    Next setting appears.
    Put your arm through the
    cuff loop.
    Your palm should face upward.
    Wrap the wrist cuff around
    your wrist.
    Wrap the wrist cuff securely
    around the wrist for taking
    accurate measurements.
    Make sure that the wrist cuff
    does not cover the protruding
    part of the wrist bone (ulna) on
    the outside of the wrist.
    • You can take a measurement on
    either your left or right wrist.
    • If the wrist cuff comes off,
    assemble as shown in the figure.
    To take a measurement, you need
    to be relaxed and comfortably
    seated, under comfortable room
    temperature. No bathing, drinking
    alcohol or caffeine, smoking,
    exercising or eating 30 minutes
    before taking a measurement.
    • Sit on a chair with your feet flat on the
    • Sit upright with your back straight.
    • The cuff should be at the same level
    as your heart.
    Press the START/STOP button.
    All the symbols appear on the display.
    While your position is improper, the Positioning symbol and the
    Positioning indicator flash, when you are in proper position the
    Positioning symbol lights on the display.
    The monitor is in
    proper position.
    The monitor is higher
    than the heart.
    The monitor is lower
    than the heart.
    3. Using the Unit
    Cuff Wrapping Guide
    Alternating date/time display
    Undo the wrist cuff and remove the unit.
    Press the START/STOP button to turn off the monitor.
    • Recent research suggests that the
    following values can be used as a
    guide to high blood pressure for
    measurements taken at home.
    Systolic Blood Pressure Above 135 mmHg
    Diastolic Blood Pressure Above 85 mmHg
    • Your blood pressure monitor includes an
    irregular heartbeat feature. Irregular
    heartbeats can influence the results of the
    measurement. The irregular heartbeat
    algorithm automatically determines if the
    measurement is usable or needs to be
    repeated. If the measurement results are
    affected by irregular heartbeats but the result
    is valid, the result is shown together with the
    irregular heartbeat symbol ( ).
    If you move during measurement, the
    movement error symbol ( ) will appear on the
    display. Keep still and repeat the measurement.
    • Wait 2 - 3 minutes before taking another
    blood pressure measurement. Waiting
    between readings allows the arteries to
    return to the condition prior to taking the
    blood pressure measurement.
    Press and hold the
    button to reset the
    Positioning sensor.
    The Positioning sensor
    is set "on" as default.
    Press the START/STOP button to store the setting.
Omron RS6

¿Necesita ayuda?

Número de preguntas: 0

¿Tiene alguna pregunta sobre Omron RS6 o necesita ayuda? Haga su pregunta aquí. Proporcione una descripción clara y completa del problema y su pregunta. Cuantos más detalles proporcione para su problema y pregunta, más fácil será para otros propietarios de Omron RS6 responder adecuadamente a su pregunta.

Vea el manual de Omron RS6 aquí, de forma gratuita. Este manual pertenece a la categoría Esfigmomanómetros y ha sido calificado por 2 personas con un promedio de 8.3. Este manual está disponible en los siguientes idiomas: Engels. ¿Tiene alguna pregunta sobre Omron RS6 o necesita ayuda? Haz tu pregunta aquí

Especificaciones de Omron RS6

Marca Omron
Modelo RS6
Producto Esfigmomanómetro
EAN 4015672107373, 4015672107380, 4015672108806
Idioma Engels
Tipo de archivo PDF
Tipo Automático
Colocación soportada Antebrazo
Impresión de fecha Si
presión arterial media Si
De medición del pulso índice Si
presión arterial diastólica Si
Presión arterial sistólica Si
Tamaño de cadena 13.5 - 21.5 cm
Función de la memoria Si
Función de voz -
Ranuras de memoria 90
Control de energía
Numero de baterías soportadas 4
Tipo de batería AA
Tipo de visualizador LCD
Número de productos incluidos 1 pieza(s)
Contenido del embalaje
Funda de transporte Si
Pilas incluidas Si

¿Busca un manual? asegura que encontrará el manual que está buscando en un abrir y cerrar de ojos. Nuestra base de datos contiene más de 1 millón de manuales en PDF de más de 10.000 marcas. Cada día añadimos los últimos manuales para que siempre encuentres el producto que buscas. Es muy sencillo: simplemente escriba el nombre de la marca y el tipo de producto en la barra de búsqueda y podrá ver instantáneamente el manual de su elección en línea de forma gratuita.

© Copyright 2021 Todos los derechos reservados.

Utilizamos cookies para asegurar que damos la mejor experiencia al usuario en nuestro sitio web. Si continúa utilizando este sitio asumiremos que está de acuerdo.

Leer más