Scosche TA2055B

Scosche TA2055B manual

(1)
  • © 2006 SCOSCHE INDUSTRIES, INC.
    SI 08/06 - TA2055B (3000003)
    If you have any further questions, call our toll free technical help line at: 1-800-621-3695x3
    TA2055B
    IN-DASH INSTALLATION KIT FOR
    2006-UP TOYOTA RAV4
    LIABILITY DISCLAIMER
    This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire harness/
    codes and information pertaining to installation of this kit (TA2055B) in 2006 Toyota RAV4 Vehicles. Scosche Industries, Inc. can
    not be held responsible for discrepancies/inconsistencies that may occur due to the automobile manufacturing changes or
    options, or damage that may occur in the automobile during the installation of components while using this booklet.
    INTRODUCTION / PRELIMINARY
    2
    For Factory Wiring Codes go to: www.scosche-cars.com
    FACTORY WIRING CODES
    CAR STEREO CONNECTORS
    PROVIDE EASY CONNECTION OF YOUR CAR
    STEREO TO FACTORY WIRING HARNESS.
    TA02
    1987-UP Toyota
    MOUNTING THE RADIO
    DIN-ISO MOUNT
    1. Snap the 6117L and 6117R brackets to the mounting locations on the 6113 kit panel. Secure
    the 6116 pocket to the 6117L/R brackets with the supplied hardware in the installation kit.
    2. Align the pocket to the lower edge of the opening in the panel. Then slide in, as shown. The
    front of the pocket should rest to front of panel. (See Illustration 2).
    3. Install (2) pocket screws as shown. (See Illustration 2).
    4. Align, position and bolt the aftermarket DIN-ISO head unit to the 6117L/6117R brackets. Use
    hardware supplied with aftermarket radio to secure the mounting brackets to the aftermarket
    radio.
    5. Snap the 6114 single DIN trim ring to complete mounting.
    VEHICLE DISASSEMBLY
    2006 TOYOTA RAV4
    Radio Removal
    1. Using a panel removal tool, remove both left and right panels located on each side off the radio.
    2. Remove the (4) 10mm bolts securing the radio to the dash. Disconnect and remove.
    This premium installation kit is for 2006-Up Toyota RAV4 vehicles. Included are all the parts you need
    to mount your car stereo/cassette or CD player into your vehicle's dash. Refer to the individual
    instruction in this manual to remove your vehicle's factory radio and assemble the kit.
    CAUTION:
    DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP
    PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/OHN METER OVER A TEST LIGHT
    TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE VEHICLE'S
    COMPUTER AND/OR DIAGNOSTIC SYSTEMS. AVOID ALL FACTORY AIRBAG WIRING - AIRBAGS CAN
    ACCIDENTALLY DEPLOY CAUSING SERIOUS INJURY OR DEATH.
    NOTES:
    See your vehicle's instructions for any special tools your installation might require.
    Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
    instructions.
    6117L
    MOUNTING
    BRACKET,
    LEFT
    VARIOUS REAR
    SUPPORT BRACKETS
    ASSEMBLED TA2055
    WITH POCKET
    DIN MOUNT
    RADIO
    6114 TRIM
    DOUBLE-DIN ISO MOUNT
    1. Snap the 6117L and 6117R brackets to the mounting locations on the 6113 kit panel.
    2. Align, position and bolt the aftermarket DIN-ISO head unit to the 6117L/6117R brackets. Use
    hardware supplied with aftermarket radio to secure the mounting brackets to the aftermarket
    radio.
    4. Snap the 6115 double DIN trim ring to
    complete mounting.
    6116 POCKET
    6113 KIT
    PANEL
    6115
    DOUBLE
    DIN
    TRIM
    RING
    6117R
    MOUNTING
    BRACKET,
    RIGHT
    6114
    SINGLE
    DIN
    TRIM
    RING
    CAUTION:
    REAR SUPPORT AVAILABLE
    SEPARATELY. REAR
    SUPPORTING THE RADIO
    ADDS TO THE INSTALLATION’S
    STRUCTURAL INTEGRITY.
    6115 TRIM
    DOUBLE DIN
    MOUNT RADIO
    ASSEMBLED TA2055
    WITH DOUBLE DIN
    ILLUSTRATION 2
    ILLUSTRATION 3
Scosche TA2055B

¿Necesita ayuda?

Número de preguntas: 0

¿Tiene alguna pregunta sobre Scosche TA2055B o necesita ayuda? Haga su pregunta aquí. Proporcione una descripción clara y completa del problema y su pregunta. Cuantos más detalles proporcione para su problema y pregunta, más fácil será para otros propietarios de Scosche TA2055B responder adecuadamente a su pregunta.

Vea el manual de Scosche TA2055B aquí, de forma gratuita. Este manual pertenece a la categoría Kits de montaje y ha sido calificado por 1 personas con un promedio de 8.3. Este manual está disponible en los siguientes idiomas: Engels. ¿Tiene alguna pregunta sobre Scosche TA2055B o necesita ayuda? Haz tu pregunta aquí

Especificaciones de Scosche TA2055B

General
Marca Scosche
Modelo TA2055B
Producto Kits de montaje
Idioma Engels
Tipo de archivo PDF
Color
Color del producto Negro
Características
Color del producto Negro

ManualPDF.es

¿Busca un manual? ManualPDF.es asegura que encontrará el manual que está buscando en un abrir y cerrar de ojos. Nuestra base de datos contiene más de 1 millón de manuales en PDF de más de 10.000 marcas. Cada día añadimos los últimos manuales para que siempre encuentres el producto que buscas. Es muy sencillo: simplemente escriba el nombre de la marca y el tipo de producto en la barra de búsqueda y podrá ver instantáneamente el manual de su elección en línea de forma gratuita.

ManualPDF.es

© Copyright 2021 ManualPDF.es. Todos los derechos reservados.

Utilizamos cookies para asegurar que damos la mejor experiencia al usuario en nuestro sitio web. Si continúa utilizando este sitio asumiremos que está de acuerdo.

Leer más