Traxxas VXL-3s

Traxxas VXL-3s manual

(1)
  • Thank you for purchasing the Traxxas VXL-3s
    electronic speed control. The Velineon
    VXL-3s
    forward/reverse electronic speed control simplifies
    brushless technology with easy, built-in profiles
    and intuitive programming. The VXL-3s uses
    advanced circuit design that allows sensorless
    brushless motors to operate with the smoothness
    and precision of the best brushless systems. The VXL-3s comes with the
    peace-of-mind of the Traxxas Lifetime Electronics Warranty and unmatched
    Traxxas customer support. The VXL-3s is not a toy. It is a sophisticated
    electronic device capable of delivering large amounts of current. Children
    under 14 years of age require adult supervision for use of the VXL-3s. If you
    have questions or need assistance call us at 1-888-TRAXXAS*.
    Important Precautions
    VXL-3s Speed Control
    Water and Electronics Do Not Mix: Your VXL-3s brushless power system
    is waterproof for use in mud, snow, puddles and other wet conditions.
    Make certain the other components of your model are waterproof or have
    sufficient water resistance before driving in wet conditions.
    Disconnect the Batteries: Always disconnect the battery pack from the
    speed control when not in use.
    Transmitter on First: Switch on your transmitter first before switching on
    the speed control to prevent runaways and erratic performance.
    Don’t Get Burned: The heat sink can get extremely hot, so be careful not
    to touch it until it is cool. Supply adequate airflow for cooling.
    Use Stock Connectors: If you decide to change the battery or motor
    connectors, only change one battery or motor connector at a time. This
    will prevent damage from accidentally mis-wiring the speed control.
    Please note that modified speed controls can be subject to a rewiring fee
    when returned for service. Removing the battery connector on the speed
    control or using the same-gender connectors on the speed control will
    void the product’s warranty.
    Insulate the Wires: Always insulate exposed or damaged wiring with heat
    shrink tubing to prevent short circuits
    Batteries and Battery Charging
    The Velineon Power System
    uses rechargeable batteries that must be
    handled with care for safety and long battery life. Make sure to read and
    follow all instructions and precautions that were provided with your battery
    packs and your charger. It is your responsibility to charge and care for your
    battery backs properly. In addition to your battery and charger instructions,
    here are some more tips to keep in mind.
    Never leave batteries to charge unattended.
    Remove the batteries from the model while charging.
    Allow the battery packs to cool off between runs (before charging).
    Always unplug the battery from the electronic speed control when the
    model is not in use and when it is being stored or transported.
    Do not use battery packs that have been damaged in any way.
    Do not use battery packs that have damaged wiring, exposed wiring, or a
    damaged connector.
    Children should have responsible adult supervision when charging and
    handling batteries.
    LiPo Batteries
    Lithium Polymer (LiPo) batteries are becoming popular for use in R/C
    models due to their compact size, high energy density, and high-current
    output. However, these types of batteries require special care and handling
    procedures for long life and safe operation. WARNING: LiPo batteries are
    intended only for advanced users that are educated on the risks associated
    with LiPo battery use. Traxxas does not recommend that anyone under
    the age of 14 use or handle LiPo battery packs without the supervision of
    a knowledgeable and responsible adult.
    The VXL-3s electronic speed control is able to use LiPo batteries with
    nominal voltage not to exceed 11.1 volts (3S packs) volts. LiPo batteries
    have a minimum safe discharge voltage threshold that should not be
    exceeded. The Velineon VXL-3s electronic speed control is equipped with
    built-in Low-Voltage Detection that alerts the driver when LiPo batteries
    have reached their minimum voltage (discharge) threshold. It is the driver’s
    responsibility to stop immediately to prevent the battery pack from
    being discharged below its safe minimum threshold.
    Low-Voltage Detection on the speed control is just one part of a
    comprehensive plan for safe LiPo battery use. It is critical for you, the user,
    to follow all other instructions supplied by the battery manufacturer
    and the charger manufacturer for proper charging, use, and storage of
    LiPo batteries. Make sure you understand how to use your LiPo batteries.
    Be aware that Traxxas shall not be liable for any special, indirect, incidental,
    or consequential damages arising out of the installation and/or use of LiPo
    batteries in Traxxas products.
    If you have questions about LiPo battery usage, please consult with your
    local hobby dealer or contact the battery manufacturer.
    Installation
    The VXL-3s will install directly into most Traxxas models in the location of
    the original speed control. Rustler, Bandit, and Stampede models require the
    use of the VXL-3s mounting plate (part #3725, sold separately). The VXL-3s
    can also be installed in the chassis with double-sided servo tape (part #1589,
    sold separately). When mounting the speed control with double-sided servo
    tape, clean both application surfaces thoroughly with alcohol. The surfaces
    must be perfectly clean for maximum adhesion.
    Here are some tips for choosing a location for the speed control:
    • The VXL-3s does not use a conventional on/off switch. Pressing the
    EZ-Set button on the speed control turns it on and off. It is not necessary
    to install an on/off switch into the wiring harness.
    If you are planning to operate the speed control at the higher limits of
    its capabilities, cut ventilation holes into the body for the heat sinks.
    Monitoring temperatures will extend the lives of
    the batteries and motor and proper ventilation and
    cooling will prevent premature thermal shutdown.
    The VXL-3s is equipped with an additional connector
    to supply power to an optional heat sink cooling fan.
    An optional heat sink cooling fan can assist in cooling
    the VXL-3s in high current motor applications.
    Mount the speed control so that none of the power components (wiring,
    motor, ESC) contacts any part of the radio system, particularly the
    antenna wire. The receiver should be mounted so the antenna wire can
    be extended as far away from the speed control as possible. The antenna
    wire should be extended vertically in the mast and not wrapped on the
    chassis under the body. Excess antenna wire should not be coiled on
    the chassis. Servo cables and the antenna wire should not cross or come
    in contact with any of the motor or battery wires. These steps will help
    reduce the possibility of radio interference.
    Mount the speed control where it will be protected from crash damage.
    Also protect the speed control from dirt and debris kicked up by the tires.
    Mount the speed control where you will have easy access to the plugs and
    the on/off (EZ-Set) button without having to remove the body.
    VXL-3s Electronic Speed Control Instructions
    Covers Part #3355R
    Specifications:
    Input voltage ...................................................... 4.8 - 11.1V (4 - 8 cells NiMH or 2S - 3S LiPo)
    Supported motors .......................................................................................... Sensorless brushless
    Battery connector .................................................................. Traxxas High-Current Connector
    Motor connectors ........................................................................ TRX 3.5mm bullet connectors
    Motor/battery wiring ............................................................................... 12-gauge Maxx® Cable
    Thermal protection ........................................................................... 2-stage thermal shutdown
    Case size (l/w/h) ........................................................55mm (2.19)/ 39mm (1.54)/ 33mm (1.3)
    Weight .................................................................................................................................. 90g (3.17oz)
    Profile Selection:
    Prole #1 (Sport Mode): 100% Forward, 100% Brakes, 100% Reverse
    Prole #2 (Race Mode): 100% Forward, 100% Brakes, No Reverse
    Prole #3 (Training Mode): 50% Forward, 100% Brakes, 50% Reverse
    TRAXXAS.com
    Traxxas, 6250 Traxxas Way, McKinney, TX 75070,
    Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
    KC2014-R02 160217
    *U.S. Customers Only
Traxxas VXL-3s

¿Necesita ayuda?

Número de preguntas: 0

¿Tiene alguna pregunta sobre Traxxas VXL-3s o necesita ayuda? Haga su pregunta aquí. Proporcione una descripción clara y completa del problema y su pregunta. Cuantos más detalles proporcione para su problema y pregunta, más fácil será para otros propietarios de Traxxas VXL-3s responder adecuadamente a su pregunta.

Vea el manual de Traxxas VXL-3s aquí, de forma gratuita. Este manual pertenece a la categoría Juguetes de radiocontrol y ha sido calificado por 1 personas con un promedio de 8.3. Este manual está disponible en los siguientes idiomas: Inglés. ¿Tiene alguna pregunta sobre Traxxas VXL-3s o necesita ayuda? Haz tu pregunta aquí

Especificaciones de Traxxas VXL-3s

General
Marca Traxxas
Modelo VXL-3s
Producto Juguete de radiocontrol
EAN 20334335586
Idioma Inglés
Tipo de archivo PDF

Preguntas frecuentes

A continuación, encontrarás las preguntas más frecuentes sobre el Traxxas VXL-3s .

¿Tu pregunta no está en la lista? Haz tu pregunta aquí

ManualPDF.es

¿Busca un manual? ManualPDF.es asegura que encontrará el manual que está buscando en un abrir y cerrar de ojos. Nuestra base de datos contiene más de 1 millón de manuales en PDF de más de 10.000 marcas. Cada día añadimos los últimos manuales para que siempre encuentres el producto que buscas. Es muy sencillo: simplemente escriba el nombre de la marca y el tipo de producto en la barra de búsqueda y podrá ver instantáneamente el manual de su elección en línea de forma gratuita.

ManualPDF.es

© Copyright 2020 ManualPDF.es. Todos los derechos reservados.

Utilizamos cookies para asegurar que damos la mejor experiencia al usuario en nuestro sitio web. Si continúa utilizando este sitio asumiremos que está de acuerdo.

Leer más